Container Bag Loading
We manufacture two models of container bag loaders: PR and APF
Both models can very greatly enhance loading palletless bags into ship containers or lorries.
VIDEOS OF CONTAINER BAG LOADING: PR and APF
Container loading equipment
We have extensive experience with the loading of bag loads and box loads into containers without pallets so you can avoid the expensive manual work.
We offer two types of bag loading systems, type APF or PR.
Ship container loading with bags without pallets type APF or PR.
The purpose of the two pallet remover system is to load ship containers to the roof with bag loads or box loads, fast and without damaging the goods in any way and without any manual work.
Both container loading system requires a standard forklift truck, the pallet remover itself type PR or APF and a standard forklift truck mounted with a push-off device, the last forklift truck shall be able to drive into a container.
Loading and unloading
The function of type APF.
A standard forklift truck places the pallets onto the pallet removers base plate, the pallet remover type APF turns the pallet vertical 180 degrees, so that wooden pallet is on top, a wooden pallet is removed, and pallet load is turned 180 degrees back. Then the load is pushed over onto a plate mounted onto the FLT forks, this either from the short side or long side, depending on the loading pattern in the container. FLT with has amounted push unit, drives into the container and push the load controlled off either on the bottom or on an already placed load. The two loads shall be palletized so, that together they fit optimum into the height of the container.
The empty pallets is stacked into a magazine, from where the forklift truck can remove them stack-wise.
No need of a smooth surface on the pallets or use of slip sheets.
The function of type PR.
The type PR is much simpler and thereby a lower investment requires though a smooth surface or a slip sheet on the pallets. A standard forklift truck places the pallets onto the pallet remover’s receiving roller conveyor, either cross or longwise, depending on the loading pattern in the container. Then an FLT mounted with a plate on the forks push the pallet away under the load through a “mailbox”, the FLT is mounted with a push system or a push-pull system, the latter when using slip sheets. The pallet load is then fully on the FLT plate and can be offloaded in the container. The empty pallet is stacked up in the pallet magazine, see the video.